Search Posts

Digital Wrench Version 4.3 Update 02/08/2022

Posted on | By admin
[featured_image]
Download
Download is available until [expire_date]
  • Version
  • Download 30526
  • File Size 68.5 MB
  • File Count 1
  • Create Date March 7, 2023
  • Last Updated September 28, 2023

Digital Wrench Version 4.3 Update 02/08/2022

Description: This update consists of all changes to Digital Wrench Version 4.3 since the original version was released in August 2021.

IMPORTANT:

-Digital Wrench software is supported ONLY ON Windows 8 or above.
-Digital Wrench WILL NOT FUNCTION CORRECTLY ON Windows XP. or Windows 7.
-Digital Wrench WILL NOT INSTALL on Windows Versions older than Windows XP.

THIS UPDATE WILL NOT INSTALL ON OLDER VERSIONS OF DIGITAL WRENCH. YOU MUST ALREADY HAVE VERSION 4.3 INSTALLED ON YOUR PC BEFORE ATTEMPTING TO INSTALL THIS UPDATE.

FOLLOW THE APPROPRIATE LINKS ON THE DEALER EXTRANET OR CONTACT POLARIS TECHNICAL SUPPORT IF YOU NEED INFORMATION ON HOW TO OBTAIN THE DIGITAL WRENCH VERSION 4.3 INSTALLER. Communication with the RZR Pro R, Indian Challenger, FTR and 2022 Chief Motorcycles is only possible using the MultiLink XP Interface Module.
SmartLink Modules will not function on these vehicles.

 

 

Update 02/08/22 Includes the following changes & additions from the original program release and Previous Updates:

- Addition of 2021 RZR 200 Models
- Addition of 2022 Ranger EV Models
- Addition of 2022 China Indian Models
- Revised Calibrations for 2020-2021 Indian Challenger Motorcycles
- Additional 2021 Indian Models

IMPORTANT: This update may also perform a firmware update on either the SmartLink or MultiLink XP Interface Module the first time it is connected. This update procedure must be allowed to complete before using the SmartLink or MultiLink XP.

NOTE: Reflashing a calibration should only be performed while working on a related issue, replacing an ECU or if there is an outstanding Service Bulletin requiring the ECU to be reflashed.

Click the link above, save the file to your hard disk and then double-click the icon to start the update process.

When the update is complete, the Version shown on the right side of the Digital Wrench Start-up Screen should read "Version 4.3 02/08/2022".

Note: Do not "run" or "open" the file from where they are. Select "save" and download them to your PC before running the install.

Category: